For new homes and additions

New Construction Radon Systems in Bountiful, UT

Tell us where your build stands and a certified radon professional who serves Davis County will call you back with a free estimate.

Building radon resistance into a new home

If you are building, the easiest time to deal with radon is before the concrete is poured. The EPA says the cost to a builder of including radon-resistant features is typically less than the cost to mitigate the home after construction. The Utah Geological Survey puts typical costs for radon-resistant construction measures at around $500 for a new residential home.

The five basic features

The EPA lists five features builders should include:

  • Gas-permeable layer. A 4-inch layer of clean, coarse gravel below the slab so soil gas can move freely under the house. Perforated pipe or a collection mat are allowed alternatives.
  • Plastic sheeting. 6 mil polyethylene or a vapor retarder on top of the gravel.
  • Vent pipe. A 3-inch or 4-inch solid PVC pipe run from the gravel layer up through the house and out the roof, labeled "Radon System."
  • Sealing and caulking. Openings, cracks and crevices in the foundation floor and walls sealed with polyurethane caulk.
  • Junction box. An electrical junction box in the attic so a vent fan can be added later if testing shows one is needed.

Passive first, active if needed

Together these features make a passive system. Utah DEQ explains that routing the pipe through a warm part of the house creates a draft, which often allows the system to operate without a fan. The EPA lists typical reductions of 30 to 70 percent for passive systems and says they are not as effective as active ones, so testing after you move in matters. If the result is 4 pCi/L or more, a fan can be added to the existing pipe.

Does Utah's building code call for it?

The Utah Geological Survey notes that while the 2015 International Residential Code is adopted statewide, its radon appendix (Appendix F) was omitted and conformance is not required. UGS recommends following those methods anyway. Codes change, so confirm current rules with your local building department.

Why not test the lot first?

Utah DEQ says that although soil testing is possible, it cannot predict how site preparation will open new radon pathways or how much vacuum the finished house will create. UGS says the same of its hazard maps: they are not intended to indicate radon levels in specific structures.

Our part

We do not build or install. If you are planning a new home or addition and want a radon professional involved, we pass your request to an independent, certified radon professional who serves Davis County. They can talk with you or your builder and give a free estimate.

Get a Free Estimate

Areas We Cover in Davis County

Parts of a radon-resistant new home

These come from the EPA's list of radon-resistant construction features. Your builder or a certified radon professional can install them.

Gravel layer and membrane

Four inches of clean, coarse gravel under the slab with plastic sheeting on top, so soil gas can travel to the vent pipe and not into the house.

Sealed slab and walls

Polyurethane caulk on openings, cracks and the slab perimeter joint to limit the paths soil gas can take indoors.

Vent pipe through the roof

Solid 3-inch or 4-inch PVC from the gravel layer through the conditioned space to above the roof, labeled as a radon system.

Attic junction box

An electrical junction box in the attic for a vent fan, in case a test after move-in shows one is needed.

Typical costs for new construction radon features

ItemPublished figureSource
Radon-resistant measures in a new homeAround $500Utah Geological Survey
Compared with mitigating after constructionTypically less for the builderEPA
Active system added to an existing structureTypically $1,200 to $1,700Utah Geological Survey

These figures are quoted from the Utah Geological Survey and the EPA and are typical figures, not quotes. The EPA says the cost to a builder can vary widely. A certified pro gives the actual quote for your plans.

Why Use a Referral for New Construction Radon Systems?

Early is easier

Contact us while the project is still in planning or foundation work and we pass your request to a certified professional before the slab goes in.

Owners and builders both welcome

We take requests from homeowners, owner-builders and contractors and pass them along the same way.

Certified radon professionals

We look for NRPP or NRSB certification. You can confirm it through each program's public search.

A free estimate for your plans

The professional who calls back prices the work for your foundation and layout at no charge.

Contact Us Today for a Free Estimate

Planning a build or an addition? Send the details and a certified radon professional will follow up with a free estimate.

Call (385) 220-8565

Free — no obligations

How it fits into a build

1. Contact us during planning

Tell us the city, the foundation type and where the project stands.

2. A certified pro calls back

They talk with you or your builder about the rough-in and give a free estimate.

3. Features go in during construction

Gravel, sheeting and the pipe stub go in before the slab is poured. Sealing, the vent run and the attic junction box follow.

4. Test after you move in

The EPA says even homes built with radon-resistant features should be tested after occupancy. At 4 pCi/L or more, a fan can be added to the pipe.

Radon Services Available in Bountiful, UT

Call (385) 220-8565Free Estimate